TWO DART STEP BY STEP SERIES
MID SHOULDER & WAIST DART [MSWD - pg. 87]
Open the WAIST & SIDE DART.PDS SLOPER TEMPLATE FILE- DOWNLOAD HERE
 
 OptiTex FUNCTIONS used for this dart modification:

  • You need to place a mark point on mid shoulder to identify new mid shoulder dart location.
  • Go to TOOLBOX>POINTS & NOTCHES>POINT ON CONTOUR left mouse click on mid shoulder contour and adjust the proportion field in the pop up menu to .5
  • Left mouse click and drag a guideline from the vertical RULER and place it over the bust point to mark the side dart location.

  • Go to TOOLBOX>DARTS & PLEATS and select the DART TOOL.
  • Hold down the ALT key and select the side seam dart tip.
  • Select the rotational center on dart line - bust point [type1.25 in submenu].
  • Select mid shoulder mark point location as the new location to move dart.
  • Select point [A] for rotation - SS dart leg nearest to armhole [A]
  • Rotate and close SS dart legs.
  • 100% of SS dart is now shifted over to the mid shoulder dart opening location.
  • You should have two darts [waist and mid shoulder] equally distributed.
  • Select closed SS dart
  • Press DELETE key to delete SS dart.
  • You need to move the new mid shoulder dart tip to be located 1 inch away from the bust point.
  • Go to TOOLBOX>DARTS & PLEATS and select the DART TOOL.
  • DO NOT HOLD DOWN the ALT key this time and select the existing dart tip - drag it to the BUST POINT to check the distance in the SHIFT DART pop up submenu and determine how much you need to move the point closer or farther away. [NOTE: example above the distance was 2.17- it was modified in image below below to 1.18]
  • In the SHIFT DART submenu type in a number to add or minus the current distance to adjust the final distance to 1 inch from the dart tip to the BUST POINT.
  • Check to see the amount you moved the mid shoulder dart tip is correct [you may need to undo and redo this step if it is incorrect.
  • Go to TOOLBOX>GENERAL>MEASURE or just press CTRL-D and check the distance to make sure the dart tip is 1 inch away from the bust point.
  • CTRL-HOME to reset piece in window.
Right mouse click on piece - under the attributes rename the PIECE -MID SHOULDER & WAIST DART, the piece DESCRIPTION - MSWD.
  • Go to TOOLBOX>UPDATE PIECES> SAVE ACTIVE AS NEW>
    Go to FILE > SAVE to save your work
 
Back to DARTS